3 replies to this topic

[10GS06061]

I recently purchased a front mask from Speed Lingerie. I am having a problem where the clip that is at the top corner on both sides which attaches to the inside of the wheel well, I am not able to get it attached. I would appreciate help or a solution from anyone that has installed one.

Thanks
Jim Dunlap
10 JSB Coupe

[HUTCH]

I recently purchased a front mask from Speed Lingerie. I am having a problem where the clip that is at the top corner on both sides which attaches to the inside of the wheel well, I am not able to get it attached. I would appreciate help or a solution from anyone that has installed one.

Thanks
Jim Dunlap
10 JSB Coupe

Not quite enough information there, Jim, but the SL bras are often a b***h to install, especially when brand new because they are so stiff. Before attempting to install it, lay the bra out in the sun for an hour or two to warm it up. That will help it become a bit more flexible as you grunt and groan to stretch it into place. You may find it helpful to have another person to help pull on the bra on the first install. The more you use it, the easier it should be to get on and off.

If all else fails and you really think there is a problem with the bra itself, call Richard at Speed Lingerie and he'll help you out. 800-570-1579 or 650-964-2584. Good Luck!

[10GS06061]

Hutch,
The SL bra has a clip on the upper corner on both the R & L top that attaches somewhere inside the wheel well. Yesterday, I did have it out in the sun to warm the material up. My wife and I attempted to install but when I could not figure out where the clip attaches, we took it off.
Does this clip have to be attached 1st and then do rest working to the center? In the wheel well there are 2 panels that overlap is this where the clip attaches? You are correct it is a B....h but will look good once properly installed
Jim

[HUTCH]

Jim, I don't own a C6 SL bra. Having owned both C5 and C4 versions. I'd just give Richard a call at Speed Lingerie and ask him wassup.